 Show Posts
|
|
Pages: [1]
|
|
2
|
Products / ScanXL / Holden / GM Enhanced PIDs
|
on: June 11, 2009, 10:13:48 pm
|
|
Are holden vehicles supported by the newly released GM Enhanced PIDs. It doesn't show it in the supported vehicles section, after all they are really a branch of GM.
|
|
|
|
|
3
|
Products / ScanXL / Re: discovery TD5 ii
|
on: August 27, 2008, 10:46:14 am
|
|
I'm pretty sure the land rovers are imported into Australia from europe, so it would be whenever it was implemented over there, which I think was around 2004.
|
|
|
|
|
4
|
Products / ScanXL / Re: discovery TD5 ii
|
on: August 22, 2008, 07:18:25 am
|
|
This is a diesel 4wd so it may even comply to EOBD, could the lack of communication be because EOBD standard was not implemented until later than 2001, 03-04?
|
|
|
|
|
5
|
Products / ScanXL / Re: discovery TD5 ii
|
on: August 13, 2008, 05:49:31 am
|
|
tried again with new configuration, no difference, still only shows trans $18. I'm fairly sure this has an ECM, TCM & BCM, ABS as well.validated PIDs with aggressive option, went from 26 to 33 available,alot were showing as unsupported in the data page. tried logging, only valid data was RPM,TPS & Load%, it also seemed to be logging at a slow data rate.Any other suggestions.
|
|
|
|
|
6
|
Products / ScanXL / discovery TD5 ii
|
on: July 19, 2008, 12:47:42 am
|
|
Tried to connect to an Australian 2001 TD5 series 2 with a drewtech mongoose cable. Scan XL would connect to the vehicle but would only show the tranny computer as $18. Is there any way to detect or connect to the engine ECM.
|
|
|
|
|
