I'm fairly new to designing virtual gauges and I had a few questions to start off and help me get into the right direction. Any help will be appreciated.
Firstly, I downloaded the trial version of DashCommand and PCMScan. I also have downloaded a virtual gauge template which I have visually edited for personalization to different PIDs for my Subaru:
My first question for everyone, how do I edit the values that are not at the start and the end of the ARC? From what I can see, I can only edit the two end points:
I also have replaced the PIDs for all 6 sensors, and I could only get the engine RPM sensor to show on the gauge. None of the Needle marks are appearing on the gauges either.