ODBLink and windows 7

[Leif]

Hi.

Does the ODBLink USB drivers support Windows 7 x64?
Can't find my ODBLink in Control Panel\Device Manager.
Regards.

/Leif

[Weston@PPE]

According to the FTDI site, the drivers are compatible with both 32bit and 64bit versions of Windows. You can download them here:
http://www.ftdichip.com/Drivers/CDM/CDM20602.zip

If the drivers are already installed, you should see a USB Serial Port (or something similar) listed under the Port (COM & LPT) section of the Device Manager. If not, it should be listed under Unknown Devices.

[kickfix]

her i corrected dead link.

http://www.ftdichip.com/Drivers/VCP.htm

scantool.net say use VCP driver not Dxxx

[kickfix]

her i corrected dead link.

http://www.ftdichip.com/Drivers/VCP.htm

scantool.net say use VCP driver not Dxxx

you just down load the unified EXE installer or DL the x64 driver and manually install driver.

here is the flow charts,,  for both types com fail, 232 com side or ecu side.
very good doc!
http://www.scantool.net/scantool/downloads/archive/flow-charts/

[Weston@PPE]

My link is directly to the setup executable from the VCP page, either link should work.