My WIFI elm scanner doesn't work on iOS 6 beta.

[corbandalas]

Hi, I've bought wifi scanner and have tried to connect it via wifi. I've entered static ip 192.168.0.12 and mask 255.255.255.0. Connection with iPhone was successfull. In iPhone it appears as CLKDevices. Next I've bought DashCommand from american App Store. In application's settings I've specified ip 192.168.0.10 and port 35000. However, when I tried to connect application told me: That it cannot open data port. I've tried it several times. It should be noticed that I'm using iOS 6 beta(tried on beta2, beta 3, and beta4 today without any success).
Also I ve tried this application on my iPad with the same settings. But iPad is running of iOS 5x. And it works fine. Have you tried DashCMD on iOS beta?

[John@PPE]

We haven't run it on the BETA. But I don't see why that should prevent us from working.

Do you have similar DashCommand settings in the iPad as the iPhone? You have the interface type set to ELM? I would try setting the dataport to AUTO.

[corbandalas]

Yes, I have the same dashcmd settings both on ipad and iPhone. The only difference is iOS version. Also I have tried auto settings on iPhone . Unfortunately , I was not able to connect too ((. And yes, I've chosen ELM

[John@PPE]

It could be that we are not compatible with the BETA version. Why don't you send a techlog to our email support. Maybe we can figure something out.

Instructions:
http://www.palmerperformance.com/forum/index.php?topic=4665.0

[corbandalas]

Ok, I will send it tomorrow morning, when I will ride the car